Replacing Intake Strainer - BMW C1 Repair Manual

Removing and installing
67 12 001
wipe/wash pump or replacing fluid
reservoir
– Remove front fairing panel.
– Swing the headlight forward and down.
– Remove running board centre section.
....................................................See Group 46
a
•
Disconnect plug (2).
•
Disconnect filler hose (1).
•
Pull fluid reservoir up to remove.
L
Note:
Fluid can escape from reservoir.
Hold the reservoir (3) in such a way that no fluid can
escape.
•
Disconnect delivery hose (4).
•
Remove fluid reservoir (3) and drain if necessary.
•
Pry pump (5) up to remove.
When installing:
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Make sure that the seal with intake filter (6) be-
tween pump and reservoir is correctly seated.
•
Make sure that hoses are correctly routed.
•
Make sure that delivery hose is not kinked.

Replacing intake strainer

– Remove pump.
•
Remove intake filter with seal (6).
1
When installing:
•
Installation is the reverse of the removal proce-
dure.
2
3
4
C1610140
5
6
C1610150
61.11