L
Note:
Use temperature measuring device,
BMW No. 00 1 900, to check heat rise.
•
Heat bearing seat to 100 °C (212 °F).
•
Pull out wheel bearing (3) with puller,
BMW No. 00 8 572, and internal puller 21/2,
BMW No. 00 8 571.
•
Remove spacer sleeve (2).
36 5 541
•
Drive out left wheel bearing (1) with drift,
BMW No. 36 5 541
36.8
Installing right/left wheel bearings
36 5 542
100
h
•
Chill wheel bearings with chilling spray, for exam-
ple.
•
Heat bearing seat to 100 °C (212 °F).
•
Press in wheel bearing until seated with drift,
BMW No. 36 5 542.
•
Install the spacer sleeve.
C1360040
e
Caution:
When pressing in the second wheel bearing, make
sure that the other wheel bearing is not forced off its
seat.
•
Chill the wheel bearing.
•
Heat bearing seat to 100 °C (212 °F).
•
Drive in second wheel bearing until seated on
seat/inner ring of spacer sleeve, using drift,
BMW No. 36 5 542.
e
Caution:
Check speed/ABS sensor gap if front wheel is in-
stalled with new wheel bearings.
Additional work when installing wheel with new
wheel bearings:
•
Check and, if necessary, adjust speed/ABS sen-
sor gap.
....................................................See Group 34
a
100
h
C1360090