Setup; Specifying The Brightness Of The Touch Screen, Leds, Channel Name Displays, And Lamps; Setting The Date And Time Of The Internal Clock - Yamaha CL3 Owner's Manual
Digital mixing console
Hide thumbs
Also See for CL3:
- Service manual (401 pages) ,
- User manual (37 pages) ,
- Installation manual (9 pages)
Table of Contents
Advertisement
Setup
This section explains the setup required when starting up
the CL series for the first time. This section will also discuss
basic operations for sending an input channel signal out
from the STEREO bus so that you can check the
connections.
Specifying the brightness of
the touch screen, LEDs,
channel name displays, and
lamps
Here is how to specify the brightness of the touch screen,
top panel LEDs, channel name displays, and lamps
connected to the rear panel LAMP connectors.
1.
In the function access area, press the SETUP
button to access the SETUP screen.
2.
In the field located in the right of the bottom
row of the SETUP screen, press the BANK A or
BANK B button.
You can save two different brightness settings in bank
A and B, and switch between them rapidly if desired.
3.
Use the multifunction knobs to set the
following parameters.
CONTRAST field
• NAME
Adjusts the contrast of the characters of the channel
name displays on the top panel.
BRIGHTNESS field
• NAME
Adjusts the brightness of the channel name displays
on the top panel.
• CH COLOR
Adjusts the brightness of the channel color indicators
on the top panel.
• SCREEN
Adjusts the brightness of the touch screen.
If you have set the brightness to lower than level 2, the
CL will start up next time with a brightness setting of
2 so that you will be able to see the screen.
• PANEL
Adjusts the brightness of the top panel LEDs. If the
optional MBCL meter bridge is installed on the
CL3/CL1, this knob setting will also affect the LEDs
on the meter bridge.
Setup
• LAMP
Adjusts the brightness of the lamps connected to the
rear panel LAMP jacks.
4.
If desired, switch between banks A and B and
make settings for the other bank in the same
way.
Now you can switch between the BANK A and BANK
B buttons to change the brightness of the touch
screen, LCD, channel name displays, and lamps in a
single operation. You can also assign this parameter to
a USER DEFINED key, and press that key to switch
between banks A and B.
Setting the date and time of
the internal clock
This section explains how to set the date and time of the
clock built into the CL unit, and how to select a date and
time display format.
The date and time you specify here will affect the time
stamp used when saving a scene.
1.
In the function access area, press the SETUP
button to access the SETUP screen.
2.
Press the DATE/TIME button located in the
bottom row of the SETUP screen, to open the
DATE / TIME popup window.
The popup window includes the following items.
1) DATE
This field specifies the date of the internal clock.
2) TIME
This field specifies the time of the internal clock.
3) DISPLAY FORMAT
This field specifies the format in which the time of the
internal clock is displayed.
3.
In the DISPLAY FORMAT field, press the
MODE buttons several times to select the
desired format for date and time display.
You can select from the following display formats.
• Date
MM/DD/YYYY (Month/Day/Year)
DD/MM/YYYY (Day/Month/Year)
YYYY/MM/DD (Year/Month/Day)
• Time
24Hours (hours shown in a range of 0–23)
12Hours (hours shown from 0am–11am, and 0pm–
11pm)
Page 35
- Quick Links:
- Audio Input/Output Connections
Hide quick links:
Advertisement
Table of Contents
