Installing A Two-Port Loop Start Module (Lsm-2); Lsm-2 Module; Figure - Mitel Inter-Tel 5000 Installation And Maintenance Manual

Installing a Two-Port Loop Start Module (LSM-2)

Install the two-port loop start module (LSM-2) as described below. Part numbers appear in
Table 6-4 on
IMPORTANT
To install the two-port Loop Start module (LSM-2):
1.
2.
3.
4.

Figure 5-18.

To remove the two-port Loop Start module (LSM-2):
1.
2.
3.
®
Inter-Tel 5000 Installation Manual – Issue 2.4, May 2008
page 6-4. See Figure 5-18 on
The loop start module can be removed with power on; however, you must
wait for the REMOVE LED indicator to change to green before removing
the module. Pressing and holding the release lever down until the LED
indicator turns green allows the software to "disconnect" from the module.
Failure to wait until the LED turns green, could result in pending informa-
tion getting lost or unexpected system behavior.
Other than the processor module, all other modules can reside in any bay.
However, DB Programming will need to change, if you move a module
(that was previously programmed) into a different bay location.
Using a properly terminated, anti-static wrist strap, remove the module from the
protective anti-static bag.
Insert the module carefully so that it aligns with the rails inside the chassis, then gently
slide the module into the chassis until it stops and the module release lever clicks into
place (up position). Do not use force.
Tighten the fastener at the top of the module, securing it to the chassis. Do not over
tighten this fastener.
If not adding any other modules, continue to "Installing the USB Security Key and Inter-
Tel Memory Card" on page
PRI Module (T1M)" on page

LSM-2 Module

Base Server Back
EXP
DUAL LS DUAL SL PAGE MOH
Processor Module
Using a properly terminated, anti-static wrist strap, loosen the fastener at the top of the
module. This fastener secures the module to the chassis.
Push down and hold the module release lever.
When the REMOVE LED turns green, grasp the module handle and carefully remove the
module from the chassis.
Installing a Two-Port Loop Start Module (LSM-2)
page 5-41.
5-19. Otherwise, continue to "Installing a Single-Port T1/E1/
5-46.
Module
Release
Lever
Chapter 5: Installation
Module-to-Chassis Fastener
Remove Module LED
LSM-2
Page 5-41