Components Of A Processor Module (Pm-1); Figure - Mitel Inter-Tel 5000 Installation And Maintenance Manual

Figure 5-16.

Processor
Module
Battery
SDRAM
Module
4.
5.
6.
®
Inter-Tel 5000 Installation Manual – Issue 2.4, May 2008

Components of a Processor Module (PM-1)

Chassis Back
expansion card
Processor
Module
Top View
NOTICE
System Inoperability. A strap covers pin 1 through pin 7 (far right in
This strap must be in place, unless using the processor expansion card
a system ever needs to function without the processor expansion card (for example,
replacing the expansion card), the strap will need to be put back on the processor
module. The standard processor module (Inter-Tel CS-5200) will not function without
the strap in place.
Insert the module carefully into the first bay (left side looking at the back of the chassis).
Make sure the module aligns with the rails inside the chassis, then gently slide the
module into the chassis until it stops. Do not use force.
Tighten the fastener at the top of the module, securing it to the chassis. Do not over
tighten this fastener.
If not adding any other modules, continue to "Installing the USB Security Key and Inter-
Tel Memory Card" on page
Module (LSM-2)" on page
Installing a Processor Module (PM-1)
Processor
mount points
Plastic
standoff (support)
5-19. Otherwise, continue to "Installing a Two-Port Loop Start
5-41.
Chapter 5: Installation
This strap must be in place.
Read the NOTICE below.
Processor
Module
Processor
Expansion Card
Screw to secure hexagon
metal standoff (support) to
expansion module and
processor module
Figure 5-16).
(page 5-38). If
Page 5-37