Dual T1/E1/Pri Module; Figure; Dual T1/E1/Pri Module Faceplate Led Summary - Mitel Inter-Tel 5000 Installation And Maintenance Manual

Chapter 5: Installation
Dual T1/E1/PRI Module LED Summary

Figure 5-20.

Module Handle
EXP
DUAL LS DUAL SL
PAGE MOH
To remove a dual T1/E1/PRI module:
1.
2.
Dual T1/E1/PRI Module LED Summary
The Dual T1/E1/PRI module has a total of 8 LEDs on the faceplate to indicate module status.
The LEDs are contained in two separate devices: a 4-LED stack, and 4 bi-color LEDs integrated
into the RJ-45 connector.
The LED stack has 2 green LEDs and 2 yellow LEDs. These LEDs are described in
and in tables
Figure 5-21.
4-LED Stack Indicators
Page 5-44

Dual T1/E1/PRI Module

Module Release Lever
Using a properly terminated anti-static wrist strap, loosen the fastener at the top of the
module (this fastener secures the module to the chassis).
Push down and hold the module release lever, and then when the REMOVE LED turns
green, grasp the module handle and carefully remove the module from the chassis.
5-3 and 5-4 on page

Dual T1/E1/PRI Module Faceplate LED Summary

Online
Remove
Busy 1
Busy 2
Module to Chassis Fastener
5-45.
RJ–45 Red/Green LEDs
®
Inter-Tel 5000 Installation Manual – Issue 2.4, May 2008
Top
Side
Chassis Back
Remove
Module LED
Dual T1/E1/PRI Module
Figure 5-21
1 2 3 4
Span #1 Span #2