Defaulting Ip Sla Settings; Placing The Ip Sla In Download Mode - Mitel Inter-Tel 5000 Installation And Maintenance Manual

Chapter 5: Installation

Defaulting IP SLA Settings

Defaulting IP SLA Settings
This allows you to change the IP SLA configuration (such as an IP address) to its default
settings.
To default the IP SLA:
1.
2.

Placing the IP SLA in Download Mode

To place the IP SLA in download mode:
1.
2.
3.
Page 5-176
Press and hold the DEFAULT button using a pinhole tool (such as a bent paper clip).
The SL STATUS LED flutters for five or six seconds. The default button is not a reset
button.
When the online LED is lit, remove the pinhole tool from the DEFAULT button. The
online LED turns off.
Power down the IP SLA by either removing the cable from the power jack, if present, or
by removing the cable from the 10BASE-T jack.
Press and hold the DEFAULT button using a pinhole tool while reconnecting power to
the IP SLA. The online and SL STATUS LEDs start flashing alternately.
Remove the pinhole tool from the DEFAULT button. The IP SLA is now in the download
mode.
To change the mode using an older IP SLA (revision level earlier than –AC), remove and
reconnect the cable from/into the 10BASE-T jack six times within three seconds. The
online and SL STATUS LEDs start flashing alternately. If the LEDs do not flash
alternately, repeat this procedure until the LEDs start flashing.
®
Inter-Tel 5000 Installation Manual – Issue 2.4, May 2008