Programming Tone Dialing; To Program Loop Calling On System Lines; Reversal On Idle - Mitel 3000 Administrator's Manual

trunk call, or when a call is forwarded or transferred to the public network.

Programming Tone Dialing

On standard CO lines on Mitel 3000, the Tone dialing option is programmed. If you program me Tone
dialing off then Pulse dialing is set.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Press the Scroll Down key ( ) until "PSTN Programming" is displayed.
•
Select "PSTN Programming".
•
Press the Scroll Down key ( ) until "Tone Dialing" is displayed.
•
Select "Tone Dialing".
The lines with Tone Dialing programmed are indicated with a "♦".
Press the speakerphone key to finish programming.

To Program Loop Calling on System Lines

This feature is used when specialized lines without dial tone are connected to the switch. These can be tie
lines or lines with external ring down equipment. When a line is programmed for loop calling the dialled
digits are not shown on the display.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Press the Scroll Down key ( ) until "PSTN Programming" is displayed.
•
Select "PSTN Programming".
•
Select "Loop Calling"
A menu showing the CO lines will be presented. The lines using Loop Calling are indicated by a "♦".
Those using the standard singling are indicated by a "◊". Select the lines as required.
Press the speakerphone key to finish programming.
Note: Last number Redial, Call Restriction, Saved Numbers, System and Personal Speed-Dial will not
work on the lines allocated as Loop Calling.

Reversal on Idle

On standard CO lines on Mitel 3000, the Reversal on Idle option is programmed. The system can then
detect when callers go on hook and automatically clear down lines. This supervision on lines enables the
trunk-to-trunk services to be available on the lines.
If Reversal on Idle is turned off then the trunk to trunk services are Timed to drop after 5 minutes
as the system cannot detect when calls have been completed.
•
• From the Programming Station, press the PROGRAM Key
•
• Press the Scroll Down Key ( ) until 'System programming' is displayed
•
• Select 'System programming'
•
• Enter the System Programming Password
•
• Select 'Lines'
•
• Press the Scroll Down Key ( )until 'PSTN programming' is displayed
•
• Select 'PSTN programming'
•
• Press the Scroll Down Key ( ) until 'Reversal on Idle' is displayed
•
• Select 'Reversal on Idle' The lines with Reversal on Idle programmed are indicated
with a ♦.
113
Mitel 3000
Administrator's Manual