Mitel Inter-Tel 5000 Installation And Maintenance Manual page 352

Chapter 6: Reference
Code-Accessible Endpoint Features
Table 6-19. Endpoint Feature Codes (Continued)
Feature
Do-Not-Disturb
Do-Not-Disturb Cancel
Do-Not-Disturb On/Off
Do-Not-Disturb Override
Enhanced Speakerphone
Enable
Feature Key Default
Group Listen
Handsfree On/Off
Headset Enable
Headset Disable
Headset On/Off
Hold – Individual
Hold – System
Hunt Group Remove
Hunt Group Replace
Hunt Group Remove/
Replace
LCD Contrast Adjustment
Message
Message – Cancel
Message – Cancel Current
Message – Silent
Page 6-30
Code
370 Halts all intercom calls, transferred calls, and pages to the endpoint. The
371 cancel code returns the endpoint to normal operation. The ON/OFF code
372 can be used to turn Do-Not-Disturb on or off. (Inter-Tel endpoints use the
DND button.)
373 (Not used on single line endpoints.) If enabled in the database, allows the
user to break through another endpoint's Do-Not-Disturb mode when
placing an intercom call.
310 (Digital endpoints only.) When entered at a digital endpoint, this feature
code enables the enhanced speakerphone. Digital endpoints can also use
∞
the + Speaker buttons.
395 (Not used on single line endpoints.) Endpoints have user-programmable
feature buttons that can be set to enter feature codes. This code returns
the user-programmable buttons to the database default values.
312 (Not used on single line endpoints.) Allows a user to transmit a
conversation over the endpoint speaker while in handset or headset
mode.
319 (Not used on single line endpoints) Disables/enables the endpoint's
handsfree intercom answering. Incoming intercom calls ring as private
calls if handsfree answering is disabled.
315 (Not used on single line endpoints.) Signals the system that a headset has
316 been connected to the endpoint when entering the enable code. The
317 disable code returns the endpoint to normal operation. The on/off feature
code can be used to toggle the feature ON or OFF.
336 Places a call on hold so that it can be picked up directly at that endpoint
or through a reverse transfer from any other endpoint. Inter-Tel endpoints
use the HOLD button.
335 Places an outside call on system hold. It can be picked up directly at any
endpoint that has an individual trunk button and has allowed-answer and/
or outgoing access for that trunk or by the endpoint that placed it on hold.
If used on conference or intercom calls, the system places the call on
Individual Hold.
322 Removes the endpoint from its assigned hunt group(s) or places it in
323 again. Does not affect non-hunt group calls. The remove/replace feature
324 code can be used to toggle the feature.
303 Adjusts the LCD contrast on the display. The endpoint must be idle to use
this feature. Models 8560, 8620/8622, 8662, and 8660 only.
365 This feature code is used for leaving and retrieving a message waiting
indication at a called endpoint or the called endpoint's message center.
Depending on how the message was left, the called endpoint user either
retrieves the message from his/her message center or from the endpoint
that left the message. Inter-Tel endpoints use the MSG button.
366 Allows the endpoint user to cancel a message waiting indication that he or
she left at another endpoint.
368 Cancels a message waiting indication that is waiting at the endpoint
without requiring the user to respond to it. Endpoints can use the asterisk
[*] button while viewing the message.
367 Leaves a message waiting indication at an endpoint without first placing
an intercom call.
Description
®
Inter-Tel 5000 Installation Manual – Issue 2.4, May 2008