Replacing The Actuator Motors For The Legrests; Disassembly; Reassembly - Invacare Twister Service Manual

Twister/Twister Junior

17.3 Replacing the actuator motors for the legrests

17.3.1

Disassembly

•
Pull the actuator motor plug to be replaced from
the connector socket.
•
Remove the upper motor fastening cover.
•
Disassemble now the actuator motor by
loosening the two fastening screws (1)
(M8 x 35 mm)

17.3.2 Reassembly

•
Insert the actuator motor and fasten it in the
legrest tapped bushes (4) by tightening the two
fastening screws (3). Do not forget the washer
(1).
•
Guide the motor cable to the corresponding
connector board and put the plug into the socket.
•
Place cover (2) onto the screw head.
•
Carry out a performance test.
Caution:
Do not tighten the fastening screws too heavily. The actuator motor must be able to
move within the fixtures.
Lay motor cable in a way where it cannot be pinched.
Service Manual
Legrest actuator motor
Reassembly of actuator
4
1
Page 158
1
1
2
3
Issued:21.01.02