Table of Contents
Advertisement
Twister / Twister Junior
•
Reinstall the lifter, turned by 180°, and place cables
again according to their original position.
•
If existing, change lighting system lamps diagonally.
•
Loosen the clamping screws (Pos. 4 in chapter 12.4)
under the aluminium section.
•
Push the aluminium section (Pos. 6 in chapter 12.4)
to the front until the motor fixing screws (Pos. 9 +
10, chapter 12.4) are visible.
•
Remove motor screws.
•
Replace the spaces (Pos. 11 in chapt. 12.4) with the anti-tip mechanism.
See chapter 12.6.
•
Screw motors and anti-tip wheels again to the lower part of the frame tubes.
•
Lay cables in a way so that they cannot get pinched or rub against other parts, and fix anew
with cable binders.
Caution:
Pay attention to the wheelbase! Vehicles with front wheel drive and lifter are supplied
as standard with the motor in the forward position (i.e. with longer wheelbase). This
means that the motors must be mounted in the front position.
•
Reinsert chassis central cover and side covers. See chapter 12.2.
•
Insert batteries and mount seating unit.
•
Set-up the relevant software.
•
Check functions according to inspection schedule. See chapter 6.
Issued: 21.01.02
Service Manual
Speed sensor
4
Page 127
Advertisement
Table of Contents
