Table of Contents
Advertisement
Twister/Twister Junior
•
Unscrew speed sensor (4) on main frame (5) and
screw on again on opposite side.
For this purpose, unscrew only the front nut. The
screw in the back serves as limit stop and for the
adjustment of the correct distance between the
magnet and the sensor. See also chapter:20.2.2
•
If existing, change lamps of the lighting system
diagonally.
•
Loosen the clamping screws (Pos. 4 in chapter 12.4)
under the aluminium section.
•
Push the aluminium section (Pos. 6 in chapter 12.4)
to the front until the motor fixing screws (Pos. 9 +
10, chapter 12.4) are visible.
•
Remove motor screws.
•
Replace the anti-tip mechanism (Pos. 11 in chapter 12.4) with the spacers.
See chapter 12.6.
•
Screw motors and anti-tip mechanism again to the lower side of the frame tubes.
•
Lay cables in a way so that they cannot get pinched or rub against other parts, and fix anew
with cable binders.
Caution:
Pay attention to the wheelbase! Vehicles with front wheel drive and lifter are supplied
as standard with the motor in the forward position (i.e. with longer wheelbase). This
means that the motors must be mounted in the front position.
•
Reinsert chassis central cover and side covers. See chapter 12.2.
•
Insert batteries and mount seating unit.
•
Set-up the relevant software.
•
Check functions according to inspection schedule. See chapter 6.
Service Manual
Speed sensor
4
Page 130
Issued:21.01.02
Advertisement
Table of Contents
