Twister/Twister Junior
12.6 Anti-tip mechanism
The anti-tip mechanism prevents that the vehicle with rear wheel drive tips over backwards
when accelerating on an ascent.
Caution:
In vehicles with rear wheel drive, the installation of the anti-tip mechanism
1. Transverse tube
2. Bush rd. 0.95 x 31.5
3. Guide tube for anti-tip device
4. Support wheel
5. Slider
6. Washer 8.4 x 17 x 1.6
7. Cheese head Allen screw
12.6.1 Disassembly of the anti-tip mechanism
•
The drive unit must be removed before disassembling the anti-tip mechanism. See chapter
12.4.1.
•
Loosen the cheese head screws (7)
•
Remove the support wheels (4) with bushes (2) and washers (6).
•
If necessary, remove sliders (5).
12.6.2 Disassembly of the anti-tip mechanism
•
Check the support wheels for damage, replace, if necessary.
•
Check the guide tubes for deformations, replace, if necessary.
12.6.3 Disassembly of the anti-tip mechanism
•
Reassembly takes place in the reverse order.
Note:
•
When converting from rear to front wheel drive, the anti-tip mechanism must be replaced by
suitable spacers. See Item 11 in chapter 12.4.
Service Manual
Anti-tip mechanism
4
2
1
4
6
3
7
Page 124
7
3
5
6
2
5
Issued:21.01.02