Axle Components; Axle; Hub And Bearings - Genie TMZ-34/19 Service Manual

Section 4 • Repair Procedures
800-610-4101
ActionRental.com

Axle Components

9-1

Axle

How to Remove the Axle
1 Lower the outriggers and adjust to level the
machine and raise the wheels off the ground.
2 Disconnect the parking brake cable at the
tension equalizer.
3 Pull the parking brake cable through the
mounting hole on the trailer.
4 Tag, disconnect and plug the brake line from
the back of the hub. Cap the fitting.
5 Clean up any brake fluid that may have spilled.
6 Repeat steps 2 through 5 for the other side.
7 Support and secure the axle assembly to an
appropriate lifting device.
8 Remove the axle mounting fasteners and
remove the axle from the machine.
Crushing hazard. The axle could
become unbalanced and fall if not
properly supported and secured
when removed from the machine.
When the axle is installed, the
brakes should be bled. Refer to
the appropriate brake
manufacturer's manual that was
shipped with your Genie TMZ.
4 - 46
9-2

Hub and Bearings

How to Remove the Hub and
Bearings
Repair procedures and additional axle information
are available in the Dexter Axle
Operation Maintenance Service Manual
(Dexter part number LIT-001-00).
Dexter Axle Operation Maintenance Service Manual
Genie part number
TMZ-34/19
June 2005
REV B
84376
Part No. 52075