Workcentre 6015 Mfp Diagnostic Test Descriptions - Xerox Phaser 6000 Service Manual

Fax/Scanner Diagnostics
Information
Scanner Maintenance
Parameter
Complete

WorkCentre 6015 MFP Diagnostic Test Descriptions

Phaser 6000/6010 and WC 6015 MFP
Scan Counter
White Balance
Shading Parameter
Registration Param.
Auto Registration
Vertical Scan Mag.
Fax Parameter
The following table below lists the diagnostic tests available, the expected results,
and a brief description of each test. If a test fails and displays an error code, use
the troubleshooting procedure in Chapter 3 specific to the error. If the test
indicates component failure, replace the failed component using the procedures in
Chapter 8. If test results are inconclusive, isolate the problem using the general
procedures in this chapter.
Caution
Do not turn the printer Off during ESS Diag testing.
Xerox Internal Use Only
Auto Adjust (FB)
Auto Adjust (ADF)
Regi FB Lead
Regi FB Side
Regi ADF Lead
Regi ADF Side
Mag FB COLOR
Mag FB GRAY
Mag ADF COLOR
Mag ADF GRAY
Continue Illegal
Thresh Memory RX (%)
Thresh Immediate (%)
Thresh Memory TX (%)
Thresh GC (%)
Page Margin 1 (mm)
Page Margin 2 (mm)
Page MAX RX (64KB)
Dis DP 20 PPS
CNG Detect (0.1s)
Auto Answer (1.0s)
Num Check (1.0s)
OnHook LCS Rate (%)
Dialtone TO (1.0s)
OnHook Detect (20ms)
Dis Dialtone
Dialtone Min (10ms)
Dialtone Max (10ms)
CNG Stop Select
G3M TX Cable EQU
G3M RX Cable EQU
G3M V34 Bit Rate
Capability V34
G3M TX Coding
G3M RX Coding
Troubleshooting
Coeff FB RED
Coeff FB GREEN
Coeff FB BLUE
Coeff FB GRAY
Coeff ADF RED
Coeff ADF GREEN
Coeff ADF BLUE
Coeff ADF GRAY
Target RED
Target GREEN
Target BLUE
Target GRAY
s6015-084
4-33