Xerox Phaser 6000 Service Manual page 221

Phaser 6000/6010 and WC 6015 MFP
Troubleshooting Procedure Table
Step Actions and Questions
4 Enter diagnostic mode and run the
Regi Sensor test (see page 4-11).
You can also use the CE Diag Tool to
run this test (see page A-9).
Lift the Main Paper Tray Chute
(PL3.3.3), does the number on the
display increase by 1 each time the
Main Paper Tray Chute is lifted?
5 Disconnect the MCU Board P/J21
and the Registration Sensor P/J120.
Check the Harness Assembly RKN
SNS for continuity.
Is the harness damaged?
6 Check that the voltage across
ground on the MCU Board P/J12-1 is
+3.3 VDC.
Is the voltage correct?
7 Check connectors P/J16 and P/J160
between the MCU Board and the
Main Drive Assembly.
Are the connectors secure?
8 Does the error persist when printing? Go to step 9.
9
Enter diagnostic mode and run the
Main Motor test (see page 4-11).
You can also use the CE Diag Tool to
run this test. (see page A-16).
Does the Main Drive Assembly
function normally?
10 Check the Main Drive Assembly for
proper installation.
Is the Main Drive Assembly installed
correctly?
11 Does the error still occur when
printing?
12 Disconnect P/J16 from the MCU
Board and P/J160 from the Main
Drive Assembly.
Check the continuity of the cable.
Is the cable damaged?
13 Check the MCU Board P/J25 for
proper connection.
Is P/J25 securely connected?
14 Does the error persist?
Xerox Internal Use Only
Error Messages and Codes
Yes No
Replace the Go to step 5.
MCU Board
(page 8-121).
Go to step 6. Repair the
harness.
Replace the Replace the
Registration MCU Board
Sensor (page 8-121).
(page 8-65).
Go to step 9. Reconnect the
connectors,
then go to
step 8.
Complete.
Go to step 14. Go to step 10.
Go to step 12. Reseat the
Main Drive
Assembly, then
go to step 11.
Go to step 12. Complete.
Repair the Go to step 13.
cable.
Go to step 15. Reconnect the
connector,
then go to
step 14.
Go to step 15. Complete.
3-85