Error Messages and Codes
Fax Board Modem Error
Applicable Error
Initial Actions
3-106
A Fax Board error is detected.
•
134-211
•
Cycle printer power.
•
If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
IP Board, PL7.1.9
Fax Board, PL7.1.22
Fax Harness. PL7.1.22
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step
Actions and Questions
1
Disconnect the Fax Harness at P/J2
on the IP Board and the
corresponding P/J on the Fax Board.
Check the Fax Harness for
continuity.
Is the cable continuos?
2
Does the error persist?
3
Replace the IP Board.
Does the error persist?
Xerox Internal Use Only
Wiring and Plug/Jack Map References
"Map 2 - Phaser 6000/6010" on
page 10-8
"Phaser 6000/6010 Image Processor
Board" on page 10-18
"Map 2 - WorkCentre 6015 MFP" on
page 10-22
"WorkCentre 6015 MFP Image
Processor Board" on page 10-32
Yes
No
Go to step 3.
Replace the
Fax Harness,
then go to
step 2.
Go to step 3.
Complete.
Replace the
Complete.
MCU Board
(page 8-121).
Phaser 6000/6010 and WC 6015 MFP