Xerox Phaser 6000 Service Manual page 606

Reference
Digital Input
A-8
PANEL Test Tests the buttons of the Control Panel.
Phaser 6010N This test checks input and output of the Control Panel. When
the Control Panel buttons are pressed, the test displays the
corresponding contents on the LCD.
Button
Up Arrow
Down Arrow
Left Arrow
Right Arrow
OK
Menu
Cancel
Up Arrow
and Down
Arrow
pressed at
same time
PANEL Test OK
Phaser 6000B
Cancel
OK/Cancel
Engine Test Communication test with the IOT.
Execute this test when the 024-371 error occurs.
Test result:
NG: See "MCU Comm Error" on page 3-51.
OK: Turn off/on the main power.
This function checks whether the Digital Input components operate normally or
not. The Digital Input test is performed for all the Digital Input components. Select
the component to test from the drop down list box, and then click the OK button.
LOW or HIGH is displayed on the Result screen. The component operation is
checked in such a way that the component status is changed from LOW to HIGH
and vice versa by operating the actuator or opening/closing the door. To stop the
operation, click the Stop button.
The following items are available for test.
Test
NO PAPER SNR
REGI SNR
EXIT SNR
K MODE SNR
IL OPEN
FAN ALARM
CRU Y/ CRU M/ CRU C/ CRU K
Xerox Internal Use Only
LCD Display
Displays "UP".
Displays "DOWN".
Displays "LEFT".
Displays "RIGHT".
Displays "SET".
Displays "MENU".
Displays "UP".
Displays "Start".
Illuminates amber LEDs.
Illuminates green LEDs.
Press both OK and Cancel to end PANEL Test.
Description
Tests the No Paper Sensor.
Tests the Registration Sensor.
Tests the Exit Sensor.
Tests the K Mode Sensor (color mode
switching sensor).
Tests the Rear Door Interlock Switch.
Not used.
Tests the Toner Cartridge sensors.
Phaser 6000/6010 and WC 6015 MFP