Xerox Phaser 6000 Service Manual page 155

Phaser 6000/6010 and WC 6015 MFP
Item Feature
7 Power Saver
8
OK
9 Jam
10
Error
11 Cancel
Phaser 6000B Extended Errors
The following errors are initially indicated by illuminating the Error LED only. To
identify which error is occurring, press and hold the OK button for more than 3
seconds to see an additional error pattern. The extended error pattern displays for
3 seconds, and then the Error LED is illuminated again. Press the OK button as
many times as necessary to identify the problem.
There are 3 cases where only the Error LED is illuminated but there is no extended
error codes.
• 077-304: Rear Door Open
• 091-402: Xero Life Warning
• 092-910: ADC Sensor Dustiness Pre-warning
Xerox Internal Use Only
Description
Indicates the printer is in the Low Power or Power
Saver Mode 2.
Flashing at the same time the Ready light is
flashing indicates the printer is canceling the
print job.
Prompts the user to press the OK button to
resume printing after an interruption.
Press OK to print side 2 of a manual 2-sided print
job after paper is reloaded.
Press and hold OK to print Printer Settings report,
Panel Settings report, and Error History report.
Flashing indicates a paper jam in the printer.
Indicates an error that needs your attention.
When flashing, the printer has a critical error that
can only be corrected by restarting the printer or
by calling for service.
When illuminated and a CMYK Toner is
illuminated, the toner should be reset.
When illuminated and a CMYK Toner is flashing,
the toner should be replaced.
When pressed, the current job is cancelled.
Error Messages and Codes
3-19