Misfeed Jam - Xerox Phaser 6000 Service Manual

Error Messages and Codes

Misfeed Jam

Applicable Error
Initial Actions
3-80
Paper jam was detected at the Main Paper Tray/Bypass Tray section of the printer.
• 075-100: Misfeed Jam
• Check the media path for obstructions or debris.
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Feed Roller, PL22.4
Feed Solenoid, PL6.1.10
Registration Sensor, PL2.3.5
Main Drive Assembly, PL6.1.2
Registration Clutch, PL2.3.7
Harness Assembly RKN SNS,
PL2.2.25
Harness Assembly Dispense MOT,
PL6.1.7
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step Actions and Questions
1 Are the Feed Roller and Separator
Pad installed correctly?
Does the Feed Roller rotate
smoothly without causing fouling?
2 Check the connections between the
MCU Board P/J12 and Registration
Sensor P/J20.
Are the connections secure?
3 Does the error persist?
Xerox Internal Use Only
Wiring and Plug/Jack Map References
"Map 3 - Phaser 6000/6010" on
page 10-9
"Phaser 6000/6010 Feeder" on
page 10-12
"Phaser 6000/6010 Drive" on
page 10-13
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
"WorkCentre 6015 MFP Feeder" on
page 10-26
"WorkCentre 6015 MFP Drive" on
page 10-27
Yes No
Go to step 2. Replace the
relevant part.
Go to step 3. Go to step 4.
Go to step 4. Complete.
Phaser 6000/6010 and WC 6015 MFP