Main Motor Failure - Xerox Phaser 6000 Service Manual

Error Messages and Codes

Main Motor Failure

Applicable Error
Initial Actions
3-26
Troubleshooting Procedure Table (Continued)
Step Actions and Questions
6 Replace the ADF (page 8-37).
Does the error persist?
• 007-340: Fuser Error
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Main Drive Assembly, PL6.1.2
Harness Assembly Main MOT,
PL 6.1.7
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step Actions and Questions
1 Check these connections
MCU Board P/J16
Main Drive Assembly P/J160
Are the connectors secure?
2 Does the error persist?
3 Check the Main Drive Assembly for
rotation. For the 6000B, see "Digital
Output Test Procedures" on
page A-16, or for the 6015 MFPs, see
"WorkCentre 6015 MFP Motor Test
Procedures" on page 4-50.
Does the Main Drive Assembly
function normally?
Xerox Internal Use Only
Yes No
Replace the IP Complete.
Board
(page 8-114).
Wiring and Plug/Jack Map References
"Map 3 - Phaser 6000/6010" on
page 10-9
"Phaser 6000/6010 Fuser" on
page 10-17
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
"WorkCentre 6015 MFP Fuser" on
page 10-31
Yes No
Go to step 3. Secure the
connectors
and then go to
step 2.
Go to step 3. Complete.
Replace the Go to step 4.
MCU Board
(page 8-121).
Phaser 6000/6010 and WC 6015 MFP