Error Messages and Codes
IP Memory Check Fail
Applicable Error
Initial Actions
3-28
Troubleshooting Procedure Table
Step
Actions and Questions
1
Reseat the Fuser and cycle system
power.
Does the error persist?
2
Check these connections
MCU Board P/J26 and P/J18.
LVPS P/J201.
Are the connectors secure?
3
Check the Fuser harness.
1. Remove the Fuser.
2. Disconnect P/J26 and P/J18 from
the MCU Board and P/J201 from
the LVPS.
Is the harness damaged?
4
Replace the Fuser (page 8-80).
Does the error persist?
A memory error occurred.
•
016-315: IP RAM R/W Check Fail
•
016-317: IP ROM Check Fail
•
Cycle printer power.
•
If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
IP Board, PL7.1.9
MCU Board, PL7.2.2
LED Driver Board, PL7.1.5
Xerox Internal Use Only
Yes
No
Go to step 2.
Complete.
Go to step 3.
Secure the
connectors.
Repair the
Go to step 4.
harness.
Replace the
Complete.
MCU Board
(page 8-121).
Wiring and Plug/Jack Map References
"Map 2 - WorkCentre 6015 MFP" on
page 10-22
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
Phaser 6000/6010 and WC 6015 MFP