Registration Jam
Phaser 6000/6010 and WC 6015 MFP
Paper remaining at the registration section of the printer was detected.
Applicable Error
•
077-901: Remain Registration Jam
Initial Actions
•
Check the media path for obstructions or debris.
•
Cycle printer power.
•
If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Registration Sensor, PL2.3.5
Harness Assembly RKN SNS,
PL2.2.25
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check connectors P/J12 on the MCU
Board and P/J120 on the
Registration Sensor.
Are the connections secure?
2
Does the error persist?
3
Enter diagnostic mode and run the
Regi Sensor test (see page 4-24).
You can also use the CE Diag Tool to
run this test (see page A-16).
Lift the Main Paper Tray Chute
(PL3.3.3).
Does the Regi Sensor test pass?
4
Does the error persist?
5
Disconnect the MCU Board P/J12.
Is the voltage across ground and
J12-1 +3.3VDC?
Xerox Internal Use Only
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 2 - Phaser 6000/6010" on
page 10-8
"Phaser 6000/6010 Feeder" on
page 10-12
"Map 2 - WorkCentre 6015 MFP" on
page 10-22
"WorkCentre 6015 MFP Feeder" on
page 10-26
Yes
Go to step 3.
Go to step 3.
Replace the
MCU Board
(page 8-121)
then go to
step 4.
Go to step 5.
Replace the
Registration
Sensor
(page 8-65).
No
Secure the
connectors,
then go to
step 2.
Complete.
Go to step 5.
Complete.
Replace the
MCU Board
(page 8-121).
3-93