Repeating Defects; Checklist Before Troubleshooting Print-Quality; Check Printer Condition - Xerox Phaser 6000 Service Manual

Repeating Defects

Checklist Before Troubleshooting Print-Quality

Check Printer Condition

Phaser 6000/6010 and WC 6015 MFP
Developer
Assembles
Transfer Roller
Fuser
xerographics
assembly
Toner
Low toner can cause print-quality problems, such as fading, streaking, white lines,
or dropouts. Print a small document from different software applications to
replicate the problem and check the amount of toner available. If the toner is low,
replace the affected cartridges.
Toner that is not genuine Xerox toner can also cause print-quality problems. If the
toner is not Xerox toner, replace the Toner Cartridge and recheck the print-quality
issue.
Cleaning
Paper, toner, and dust particles can accumulate inside the printer and cause print-
quality problems such as smearing or specks. Clean the inside of the printer to
reduce these problems. Start by printing 10 blank sheets of paper, and then refer
to "Cleaning" on page 7-3.
Xerox Internal Use Only
Component Part Number
Transfer Roller PL1.1.9
H/R PL5.1.1
drum PL3.3.1
BCR PL3.3.1
BCR-CLN ROLL PL3.3.1
MAG ROLL PL3.3.1
1st BTR PL3.3.1
Back Up ROLL PL3.3.1
ID ROLL PL3.3.1
Image Quality
Roll Diameter
Interval (mm)
(mm)
14 44.0
21.37 67.1
30 94.3
9 28.3
8 25.1
12.5 39.3
10 31.4
15.85 49.8
16 50.2
5-3