Power Supply Troubleshooting; Ac Power Troubleshooting - Xerox Phaser 6000 Service Manual

Power Supply Troubleshooting

AC Power Troubleshooting

Phaser 6000/6010 and WC 6015 MFP
Initial Actions
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Procedure Table
Step Actions and Questions
1 When the printer is turned on, can
you hear the motor?
2 Connect the power cord to a
different outlet.
Does the printer now work?
3 Check that the power cord is
plugged in to both the printer and
the outlet.
Does the printer now work?
4 Disconnect the power cord and wait
for 1 minute. Reseat all of the
connectors on the LVPS, and then
turn the printer on.
Does the printer now work?
5 Disconnect the power cord and wait
for 1 minute. Reseat the AC Inlet
Harness (PL7.2.9), and then turn the
printer on.
Does the printer now work?
Xerox Internal Use Only
Troubleshooting
Yes No
Go to "DC Power Go to step 2.
Troubleshooting"
on page 4-68.
Complete. Go to step 3.
Complete. Go to step 4.
Complete. Go to step 5.
Complete. Replace the
LVPS
(page 8-119).
4-67