Xerox Phaser 6000 Service Manual page 609

Phaser 6000/6010 and WC 6015 MFP
Test Procedure
REGI SNR 1. Power on the printer, and start the CE Diag Tool.
2. Click the CE Diag tab, and then select Digital Input.
3. Open the Rear Door.
4. Select the REGI SNR test, and click the OK button.
5. Manually operate the actuator to check whether the sensor
functions properly.
Actuator
6. Click the Stop button to stop the test.
7. Close the Rear Door.
Test example:
[12:08]
Digital Input Mode = ENTRY
[12:08]
REGI SNR = LOW
STARTED = REGI SNR
[12:08]
REGI SNR = HIGH
STARTED = REGI SNR
[12:08]
REGI SNR = LOW
STARTED = REGI SNR
[12:08]
Digital Input Mode = EXIT
Xerox Internal Use Only
Reference
Registration Sensor
s6000-144
A-11