Xerox Phaser 6000 Service Manual page 210

Error Messages and Codes
3-74
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the P/J10 connector on the
MCU Board.
Is P/J10 connected correctly?
2 Does the error persist when the
power is turned on?
3 Test the Feed Solenoid.
Enter diagnostic mode and select
Engine Diag > Motor Test > K Mode
Solenoid (see "Using Phaser 6010N
and WorkCentre 6015 MFP Service
Diagnostics" on page 4-10).
You can also use the CE Diag Tool to
perform this test (page A-16).
Does the Feed Solenoid function
normally?
4 Check the connections between the
MCU Board P/J12 and the Feed
Sensor P/J122.
Are the connections secure?
5
Does the error persist when the
power is turned on?
6 Disconnect the MCU Board P/J21
and the Registration Sensor P/J120.
Check the Harness Assembly RKN
SNS for continuity.
Is the harness damaged?
7 Disconnect P/J12 on the MCU
Board. Is the voltage across ground
to P/J12-7 approximately +3.3 VDC?
Xerox Internal Use Only
Yes No
Go to step 2. Reseat the
connector. Go
to step 2.
Go to step 3. Complete.
Go to step 4. Replace the
Feed Solenoid
(page 8-98).
Go to step 5. Reseat the
connector. Go
to step 5.
Go to step 6. Complete.
Repair the Go to step 7.
harness.
Replace the Replace the
Developer Drive MCU Board
Assembly. (page 8-121).
Phaser 6000/6010 and WC 6015 MFP