Toner Cartridge Installation - Ricoh D093 Service Manual

Main Machine Installation (D093/D094)
17. Open the second 1 kg pack of developer, then slowly add it to the development unit. Move
the pack from left to right until it is empty.
18. Use a clean cloth to clean the edges around the slot of the development unit.
19. Close the upper unit.

Toner Cartridge Installation

To prepare a toner cartridge for installation
Please install and use the toner cartridge that is designed for this machine.
1. Remove the cartridge from its package.
2. Gently tap the capped end of the cartridge [1] 4 or 5 times.
3. Tap the other end of the cartridge 4 or 5 times.
4. Shake the cartridge from side to side 4 or 5 times so the toner moves freely inside the
cartridge.
5. Rotate the joint [2] to confirm that it rotates easily. If the joint does not rotate easily, tap the
ends of the cartridge and shake it again.
Show the operators this procedure so that they know how to load the cartridge
properly.
If the toner is not loosened inside the cartridge before it is installed, the operator may
hear a rattling noise when the main machine is switched on. (The noise is caused by
agitators inside the cartridge that disengage if compacted toner prevents them from
rotating.)
D093/D094 3-20 SM