Alcatel-Lucent 7210 SAS E OS Configuration Manual page 97

encap-type
Syntax encap-type {dot1q | null}
no encap-type
Context config>lag
Description
This command configures the encapsulation method used to distinguish customer traffic on a LAG.
The encapsulation type is configurable on a LAG port. The LAG port and the port member
encapsulation types must match when adding a port member.
If the encapsulation type of the LAG port is changed, the encapsulation type on all the port members
will also change. The encapsulation type can be changed on the LAG port only if there is no interface
associated with it. If the MTU is set to a non default value, it will be reset to the default value when
the encap type is changed.
The no form of this command restores the default.
Default null — All traffic on the port belongs to a single service or VLAN.
Parameters
dot1q — Ingress frames carry 802.1Q tags where each tag signifies a different service.
null — Ingress frames will not use any tags to delineate a service. As a result, only one service can be
hold-time
Syntax hold-time down hold-down-time
no hold-time
Context config>lag
Description This command specifies the timer, in tenths of seconds, which controls the delay between detecting
that a LAG is down (all active ports are down) and reporting it to the higher levels.
A non-zero value can be configured, for example, when active/standby signalling is used in a 1:1
fashion to avoid informing higher levels during the small time interval between detecting that the
LAG is down and the time needed to activate the standby link.
Default
0
Parameters down hold-down-time — Specifies the hold-time for event reporting
7210 SAS E Interface Configuration Guide
configured on a port with a null encapsulation type.
Values
0 — 2000
Interface Configuration
Page 97