Alcatel-Lucent 7210 SAS E OS Configuration Manual page 90

802.1x Port Commands
dot1x
Syntax dot1x
Context config>port>ethernet
Description This command enables access to the context to configure port-specific 802.1x authentication
attributes. This context can only be used when configuring a Fast Ethernet, gigabit or 10Gig
EthernetFast Ethernet, gigabit or 10Gig EthernetFast Ethernet or gigabit Ethernet LAN ports on an
appropriate MDA.
keep-alive
Syntax keep-alive timer
no keep-alive
Context config>port>ethernet>dwl
Description This command configures the time interval between keep-alive PDUs.
Default
no keep-alive
Parameters
timer — Specifies the time interval, in seconds, between keep-alive PDUs.
retry-timeout
Syntax retry-timeout timer
no retry-timeout
Context config>port>ethernet>dwl
Description This command configures the minimum wait time before re-enabling port after loop detection.
Default
no retry-timeout
Parameters
timer — Specifies the minimum wait time before re-enabling port after loop detection.
Page 90
Values
1 — 120
Values
0, 10 — 160
7210 SAS E Interface Configuration Guide