Alcatel-Lucent 7210 SAS E OS Configuration Manual page 100

LAG Commands
selection-criteria
Syntax selection-criteria [highest-count | highest-weight] [slave-to-partner]
no selection-criteria
Context config>lag
Description This command specifies which selection criteria should be used to select the active sub-group.
Default
highest-count
Parameters
highest-count — Specifies sub-group with the highest number of eligible members.
highest-weight — Specifies sub-group with the highest aggregate weight.
slave-to-partner — The slave-to-partner keyword specifies that it, together with the selection
Page 100
between active and standby links in case no links are usable for a short time, especially in case a
subgroup consists of one member.
Values 1 — 8 identifies a LAG subgroup.
The auto-iom subgroup is defined based on the IOM (all ports of the same IOM
are assigned to the same subgroup).
The auto-mda subgroup is defined based on the MDA.
criteria, should be used to select the active sub-group. An eligible member is a lag-member link
which can potentially become active. This means it is operationally up (not disabled) for use by
the remote side. The slave-to-partner parameter can be used to control whether or not this latter
condition is taken into account.
7210 SAS E Interface Configuration Guide