Alcatel-Lucent 7210 SAS E OS Configuration Manual page 88

802.1x Port Commands
re-auth-period
Syntax re-auth-period seconds
no re-auth-period
Context config>port>ethernet>dot1x
Description This command configures the period after which re-authentication is performed. This value is only
relevant if re-authentication is enabled.
The no form of this command returns the value to the default.
Default
3600
Parameters
seconds — The re-authentication delay period in seconds.
re-authentication
Syntax [no] re-authentication
Context config>port>ethernet>dot1x
Description This command enables / disables periodic 802.1x re-authentication.
When re-authentication is enabled, the 7210 SAS will re-authenticate clients on the port every re-
auth-period seconds.
The no form of the command returns the value to the default.
Default
re-authentication
server-timeout
Syntax server-timeout seconds
no server-timeout
Context config>port>ethernet>dot1x
Description This command configures the period during which the 7210 SAS waits for the RADIUS server to
responds to its access request message. When this timer expires, the 7210 SAS will re-send the
access request message, up to the specified number times.
The no form of this command returns the value to the default.
Default
30
Parameters seconds — The server timeout period in seconds.
Page 88
Values
1 — 9000
Values
1 — 300
7210 SAS E Interface Configuration Guide