Alcatel-Lucent 7210 SAS E OS Configuration Manual page 93

Access Uplink Port Commands
uplink
Syntax uplink
Context config>port>access
Description
This command enables the context to configure access uplink egress port parameters.
accounting-policy
Syntax accounting-policy policy-id
no accounting-policy
Context config>port>ethernet>access>uplink
config>port>ethernet>access
Description
This command configures an accounting policy that can apply to an interface.
An accounting policy must be configured before it can be associated to an interface. If the accounting
policy-id does not exist, an error is returned.
Accounting policies associated with service billing can only be applied to SAPs. Accounting policies
associated with network ports can only be associated with interfaces. Only one accounting policy can
be associated with an interface at a time.
The no form of this command removes the accounting policy association from the network interface,
and the acccounting policy reverts to the default.
Default
No accounting policies are specified by default. You must explicitly specify a policy. If configured,
the accounting policy configured as the default is used.
Parameters policy-id — The accounting policy-id of an existing policy. Accounting policies record either service
7210 SAS E Interface Configuration Guide
(access) or network information. A network accounting policy can only be associated with the
network port configurations. Accounting policies are configured in the config>log>accounting-
policy context.
Values
1 — 99
Interface Configuration
Page 93