Alcatel-Lucent 7210 SAS E OS Configuration Manual page 106

Eth Ring Commands
Parameters priority — Specifies the priority of CCM and LTM messages.
eth-test-enable
Syntax [no] eth-test-enable
Context config>eth-ring>path>eth-cfm>mep
Description This command enables eth-test functionality on MEP. For this test to work, operators need to
configure ETH-test parameters on both sender and receiver nodes. The ETH-test then can be done
using the following OAM commands:
oam eth-cfm eth-test mac-address mep mep-id domain md-index
association ma-index [priority priority] [data-length data-length]
A check is done for both the provisioning and test to ensure the MEP is an Y.1731 MEP (MEP
provisioned with domain format none, association format icc-based). If not, the operation fails. An
error message in the CLI and SNMP will indicate the problem.
test-pattern
Syntax test-pattern {all-zeros | all-ones} [crc-enable]
no test-pattern
Context config>eth-ring>path>eth-cfm>mep>eth-test-enable
Description
This command configures the test pattern for eth-test frames.
The no form of the command removes the values from the configuration.
Parameters all-zeros — Specifies to use all zeros in the test pattern.
all-ones — Specifies to use all ones in the test pattern.
crc-enable — Generates a CRC checksum.
Default
all-zeros
bit-error-threshold
Syntax bit-error-threshold bit-errors
Context config>eth-ring>path>eth-cfm>mep
Description
This command specifies the lowest priority defect that is allowed to generate a fault alarm.
Default
1
Parameters bit-errors — Specifies the lowest priority defect.
Page 106
Values
0 — 7
7210 SAS E Interface Configuration Guide