Alcatel-Lucent 7210 SAS E OS Configuration Manual page 160

LAG Commands
Page 160
Label
Hold-Time Down
LACP
LACP Transmit
Intvl
Selection Crite-
ria
Number of sub-
groups
System ID
Admin Key
Oper Key
System Priority
Prtr System ID
Prtr Oper Key
Prtr System Pri-
ority
Mode
Opr
Port Threshold
Thres. Exceeded
Cnt
Threshold Action
Encap Type
Lag-IFIndex
Port ID
(LACP) Mode
LACP xmit
standby
Description (Continued)
The timer, in tenths of seconds, which controls the delay between
detecting that a LAG is down and reporting it to the higher levels.
Enabled — LACP is enabled.
Down — LACP is disabled.
LACP timeout signalled to peer.
Configured subgroup selection criteria.
Total subgroups in LAG.
System ID used by actor in LACP messages.
Configured LAG key.
Key used by actor in LACP messages.
System priority used by actor in LACP messages.
System ID used by partner in LACP messages.
Key used by partner in LACP messages.
System priority used by partner in LACP messages.
LAG in access or network mode.
Up — The LAG is operationally up.
Down — The LAG is operationally down.
Configured port threshold.
The number of times that the drop count was reached.
Action to take when the number of available links is equal or below the
port threshold.
The encapsulation method used to distinguish customer traffic on a
LAG.
A box-wide unique number assigned to this interface.
The specific slot/MDA/port ID.
LACP active or passive mode.
LACP transmits on standby links enabled / disabled.
7210 SAS E Interface Configuration Guide