Configuring Ports
Configuring Ports
The following example displays the default port pool configurations.
*A:card-1>config>port# info detail
----------------------------------------------
...
----------------------------------------------
*A:card-1>config>port#
Configuring Ethernet Port Parameters
Ethernet Access Uplink Port
An access uplink port is network facing and participates in the service provider transport or
infrastructure network processes. This is similar to a network port concept, except that the 7210
SAS E does not allow IP interfaces nor runs routing protocols.
A SAP can be created when a port is configured in access uplink mode. When a port is configured
in access uplink mode, then the encapsulation type of the port is set to QinQ.
The following example displays a network port configuration:
A:ALA-B>config>port# info
----------------------------------------------
description "Ethernet Access Uplink port"
----------------------------------------------
Page 52
description "10/100/Gig Ethernet SFP"
access
egress
pool default
resv-cbs default
slope-policy "default"
exit
exit
uplink
egress
pool default
resv-cbs default
slope-policy "default"
exit
exit
exit
exit
ethernet
mode access uplink
exit
7210 SAS E Interface Configuration Guide