Alcatel-Lucent 7210 SAS E OS Configuration Manual page 91

LLDP Port Commands
lldp
Syntax lldp
Context config>port>ethernet
Description
This command enables the context to configure Link Layer Discovery Protocol (LLDP) parameters
on the specified port.
dest-mac
Syntax dest-mac {bridge-mac}
Context config>port>ethernet>lldp
Description
This command configures destination MAC address parameters.
Parameters
bridge-mac — Specifies destination bridge MAC type to use by LLDP.
admin-status
Syntax admin-status {rx | tx | tx-rx | disabled}
Context config>port>ethernet>lldp>dstmac
Description
This command specifies the desired administrative status of the local LLDP agent.
Parameters
rx — Specifies that the LLDP agent receives LLDP frames on this port, also indicates that the LLDP
tx — Specifies that the LLDP agent transmits LLDP frames on this port and does not store any
tx-rx — Specifies that the LLDP agent transmitw and receives LLDP frames on this port.
disabled — Specifies that the LLDP agent does not transmit or receive LLDP frames on this port. If
7210 SAS E Interface Configuration Guide
Values
nearest-bridge — Specifies to use the nearest bridge.
nearest-non-tpmr — Specifies to use the nearest non-Two-Port MAC Relay
(TPMR) .
nearest-customer — Specifies to use the nearest customer.
agent does not transmit LLDP frames.
information about the remote systems connected.
there is remote systems information which is received on this port and stored in other tables,
before the port's admin status becomes disabled, then the information will naturally age out.
Interface Configuration
Page 91