Alcatel-Lucent 7210 SAS E OS Configuration Manual page 75

General Port Commands
port
Syntax port
no port
Context config
Description This command enables access to the context to configure ports. Before a port can be configured, the
chassis slot must be provisioned with a valid card type and the MDA parameter must be provisioned
with a valid MDA type. (See card and mda commands.)
Default
No ports are configured. All ports must be explicitly configured and enabled.
Parameters port-id — Specifies the physical port ID in the slot/mda/port format.
egress-scheduler-policy
Syntax egress-scheduler-policy port-scheduler-policy-name
no egress-scheduler-policy
Context config>port>ethernet
Description
The default scheduling done for a port is strict scheduling. When a port-scheduler-policy is applied to
the port, the scheduling behavior changes to the one specified in the policy (Strict, RR, WRR,
WDRR, WRR/WDRR + Strict).
The no form of the command removes the policy from the port and makes the scheduling scheme of
the port to strict.
mode
Syntax mode {access} [uplink]
no mode
Context config>port>ethernet
Description This command configures an Ethernet port for access or access uplink mode operation.
An access port is used for customer facing traffic on which services are configured. A Service Access
Point (SAP) can only be configured on an access port or channel. When a port is configured for
access mode, the appropriate encap-type must be specified to distinguish the services on the port.
Once an Ethernet port has been configured for access mode, multiple services can be configured on
the Ethernet port.
7210 SAS E Interface Configuration Guide
Interface Configuration
Page 75