Alcatel-Lucent 7210 SAS E OS Configuration Manual page 71

Card Commands
card
Syntax card slot-number
Context config
Description This mandatory command enables access to the chassis card Input/Output Module (IOM), slot, and
MDA CLI context.
The no form of this command cannot be used on fixed IOM and MDA cards that are auto equipped
and auto provisioned.
Default
No cards are configured. The IOM card is equipped and provisioned for slot 1.
Parameters
slot-number — The slot number of the card in the chassis.
card-type
Syntax card-type card-type
card-type card-type
Context config>card
Description
This mandatory command adds an to the device configuration for the slot. The card type can be
preprovisioned, meaning that the card does not need to be installed in the chassis.
A card must be provisioned before an MDA or port can be configured.
A card can only be provisioned in a slot that is vacant, meaning no other card can be provisioned
(configured) for that particular slot.
A card can only be provisioned in a slot if the card type is allowed in the slot. An error message is
generated if an attempt is made to provision a card type that is not allowed.
A high severity alarm is raised if an administratively enabled card is removed from the chassis. The
alarm is cleared when the correct card type is installed or the configuration is modified. A low
severity trap is issued when a card is removed that is administratively disabled.
An appropriate alarm is raised if a partial or complete card failure is detected. The alarm is cleared
when the error condition ceases.
The no form of this command cannot be used as the IOM card is fixed.
Default
The IOM card is equipped and preprovisioned for slot 1.
7210 SAS E Interface Configuration Guide
Interface Configuration
Page 71