Alcatel-Lucent 7210 SAS E OS Configuration Manual page 82

Ethernet Port Commands
tunneling
Syntax [no] tunneling
Context config>port>ethernet>efm-oam
Description This command enables EFM OAM PDU tunneling. Enabling tunneling will allow a port mode Epipe
SAP to pass OAM frames through the pipe to the far end.
The no form of the command disables tunneling.
Default
no tunneling
egress-rate
Syntax egress-rate sub-rate [max-burst burst-size]
no egress-rate
Context config>port>ethernet
Description This command configures the rate of traffic leaving the network.
The no form of this command returns the value to the default.
Default
no egress-rate
Parameters
sub-rate — The egress rate in Kbps.
max-burst burst-size — The maximum egress burst in kilobits (Kbits).
encap-type
Syntax encap-type {dot1q | null}
no encap-type
Context config>port>ethernet
Description
This command configures the encapsulation method used to distinguish customer traffic on an
Ethernet access port, or different VLANs on a port. In the 7210 SAS E, QinQ encap-type can be
specified only for access uplink ports and null and the Dot1q encap-type can be specified only for
access ports.
The no form of this command restores the default.
Default
null
Parameters
dot1q — Ingress frames carry 802.1Q tags where each tag signifies a different service.
Page 82
Values
1 — 10000000
Values
32 — 16384
7210 SAS E Interface Configuration Guide