Alcatel-Lucent 7210 SAS E OS Configuration Manual page 81

accept-remote-loopback
Syntax [no] accept-remote-loopback
Context config>port>ethernet>efm-oam
Description
This command enables reactions to loopback control OAM PDUs from peers.
The no form of this command disables reactions to loopback control OAM PDUs.
Default no accept-remote-loopback
mode
Syntax mode {active | passive}
Context config>port>ethernet>efm-oam
Description
This command configures the mode of OAM operation for this Ethernet port. These two modes differ
in that active mode causes the port to continually send out efm-oam info PDUs while passive mode
waits for the peer to initiate the negotiation process. A passive mode port cannot initiate monitoring
activites (such as loopback) with the peer.
Default active
Parameters
active — Provides capability to initiate negotiation and monitoring activities.
passive — Relies on peer to initiate negotiation and monitoring activities.
transmit-interval
Syntax [no] transmit-interval interval [multiplier multiplier]
Context config>port>ethernet>efm-oam
Description
This command configures the transmit interval of OAM PDUs.
Default transmit-interval 10 multiplier 5
Parameters
interval — Specifies the transmit interval.
multiplier multiplier — Specifies the multiplier for transmit-interval to set local link down timer.
7210 SAS E Interface Configuration Guide
Values 5 — 600 (in 100 milliseconds)
Values
2 — 5
Interface Configuration
Page 81