Alcatel-Lucent 7210 SAS E OS Configuration Manual page 147

Hide thumbs Also See for 7210 SAS E OS:
Table of Contents

Advertisement

Ethernet-like Medium Statistics — the following table describe Ethernet-like Medium Statistics
field..
7210 SAS E Interface Configuration Guide
Label
Alignment Errors
FCS Errors
SQE Errors
CSE
Too long Frames
Symbol Errors
Sngl Collisions
Mult Collisions
Late Collisions
Excess Colli-
sions
Int MAC Tx Errs
Int MAC Rx Errs
Multicast Pckts
Undersize Pckts
The total number of packets received that had a length (excluding
framing bits, but including FCS octets) of between 64 and 1518 octets,
inclusive, but that had either a bad Frame Check Sequence (FCS) with
an integral number of octets (FCS Error) or a bad FCS with a non-inte-
gral number of octets.
The number of frames received that are an integral number of octets in
length but do not pass the FCS check.
The number of times that the SQE TEST ERROR is received.
The number of times that the carrier sense condition was lost or never
asserted when attempting to transmit a frame.
The number of frames received that exceed the maximum permitted
frame size.
For an interface operating at 100 Mb/s, the number of times there was
an invalid data symbol when a valid carrier was present
The number of frames that are involved in a single collision, and are
subsequently transmitted successfully.
The number of frames that are involved in more than one collision and
are subsequently transmitted successfully.
The number of times that a collision is detected later than one slot
Time into the transmission of a packet.
The number of frames for which a transmission fails due to excessive
collisions.
The number of frames for which a transmission fails due to an internal
MAC sub-layer transmit error.
The number of frames for which a reception fails due to an internal
MAC sub-layer receive error.
The number of packets, delivered by this sub-layer to a higher (sub-)
layer, which were not addressed to a unicast or broadcast address at
this sub-layer. The total number of packets that higher-level protocols
requested be transmitted, and which were not addressed to a unicast or
broadcast address at this sub-layer, including those that were discarded
or not sent.
The total number of packets received that were shorter than 64 octets
(excluding framing bits, but including FCS octets) but were otherwise
well formed.
Interface Configuration
Description
Page 147

Advertisement

Table of Contents
loading

Table of Contents