Alcatel-Lucent 7210 SAS E OS Configuration Manual page 152

Port Show Commands
A:7210>show# port A/1 detail
===============================================================================
Ethernet Interface
===============================================================================
Description
Interface
Link-level
Admin State
Oper State
Physical Link
Single Fiber Mode
IfIndex
Last State Change
Last Cleared Time
Configured Mode
Dot1Q Ethertype
PBB Ethertype
Ing. Pool % Rate
Ing. Pool Policy
Egr. Pool Policy
Net. Egr. Queue Pol:
Page 152
Label
Traffic Statis-
tics
Ethernet Statis-
tics
: 10/100 Ethernet TX
: A/1
: Ethernet
: up
: up
: Yes
: No
: 67141632
: 07/09/2010 16:30:04
: N/A
: network
: 0x8100
: 0x88e7
: 100
: n/a
: n/a
Description (Continued)
Octets input/output – the total number of octets received and
transmitted on the port Packets input/output – the number of packets,
delivered by this sub-layer to a higher (sub-) layer, which were not
addressed to a multicast or broadcast address at this sublayer. The total
number of packets that higher-level protocols requested be transmitted,
and which were not addressed to a multicast or broadcast address at
this sub-layer, including those that were discarded or not sent.
Errors input/output – for packet-oriented interfaces, the number of
inbound packets that contained errors preventing them from being
deliverable to a higher-layer protocol. For character-oriented or fixed-
length interfaces, the number of inbound transmission units that
contained errors preventing them from being deliverable to a higher-
layer protocol.
For packet-oriented interfaces, the number of outbound packets that
could not be transmitted because of errors. For character-oriented or
fixed length interfaces, the number of outbound transmission units that
could not be transmitted because of errors.
Broadcast Pckts — the number of packets, delivered by this sub-layer
to a higher (sub-) layer, which were not addressed to a unicast or
multicast address at this sub-layer. The total number of packets that
higher-level protocols requested be transmitted, and which were not
addressed to a unicast or multicast address at this sub-layer, including
those that were discarded or not sent.
7210 SAS E Interface Configuration Guide
Oper Speed : 10 mbps
Config Speed : 100 mbps
Oper Duplex : half
Config Duplex : full
MTU : 1514
Hold time up : 0 seconds
Hold time down : 0 seconds
Encap Type : null
QinQ Ethertype : 0x8100
Egr. Pool % Rate : 100
Network Qos Pol : n/a