Alcatel-Lucent 7210 SAS E OS Configuration Manual page 159

Lag-id
-------------------------------------------------------------------------------
1
2
3
4
10
-------------------------------------------------------------------------------
Total Lag-ids: 5
===============================================================================
A:ALA-48>config# show lag
*A:stu-1>config>service>epipe# show lag 1 detail
===============================================================================
LAG Details
===============================================================================
-------------------------------------------------------------------------------
Details
-------------------------------------------------------------------------------
Lag-id
Adm
Reason Down
Encap Type
Configured Address
Hardware Address
Hold-time Down
LACP
-------------------------------------------------------------------------------
Port-id
-------------------------------------------------------------------------------
1/1/21
1/1/22
===============================================================================
*A:stu-1>config>service>epipe#
Detailed LAG Output — The following table describes detailed LAG output fields.
Detailed LAG Output Fields
7210 SAS E Interface Configuration Guide
Adm
up
up
up
up
up
: 1
: up
: linkLossFwd
: null
: 00:0a:ab:b1:c0:1c
: 00:0a:ab:b1:c0:1c
: 0.0 sec
: disabled
Adm Act/Stdby Opr
up active
up active
Label
LAG ID
Adm
Port Threshold
Thres. Last
Cleared
Dynamic Cost
Configured
Address
Hardware Address
Opr Port-Threshold
down 0
up 0
down 0
down 0
down 0
Single Chassis: 2
Mode
Opr
Lag-IfIndex
Uplink
Primary
down yes
down
The LAG or multi-link trunk (MLT) that the port is assigned to.
Up — The LAG is administratively up.
Down — The LAG is administratively down.
If the number of available links is equal or below this number, the
threshold action is executed.
The last time that keepalive stats were cleared.
The OSPF costing of a link aggregation group based on the available
aggregated, operational bandwidth.
The base chassis Ethernet MAC address.
The hardware address.
Interface Configuration
Up-Link-Count MC Act/Stdby
0 N/A
1 active
0 standby
0 standby
0 N/A
MC Act: 1 MC Stdby: 2
: access
: down
: 1342177281
: No
Sub-group Forced
1 -
1 -
Description
Prio
32768
32768
Page 159