Ram Simm; Figure 8-37 Installing The Ram Simm On The Image Processor Board - Tektronix Phaser 440 Service Manual

RAM SIMM

Tools required
#1 POSIDRIV® screwdriver
1. Power down the printer. Leave the power cord plugged in to provide
a ground path for static discharges.
2. Remove the top-rear and rear cabinet panels. Refer to the earlier topic
"Printer cabinet panels" on page 8-4
3. Remove the card cage top (3 screws).
4.
Flip over the hinged card cage top.
5. Insert a memory module in connector J7 (a), and tilt the module down
until it locks in place (b).
When properly inserted, a tab on each end of the connector slips into a
hole on each end of the RAM SIMM. Also, a pawl on each end of the
connector latches around each end of the RAM SIMM to lock it in
place.
J9
J8
J7
J6
a
b

Figure 8-37 Installing the RAM SIMM on the image processor board

6. Repeat Step 3 to install an additional memory module in J8 and then J9
if additional SIMMs are available.
7.
Reinstall the card cage top and the rear cabinet panels.
8. Reconnect the host interface cables. Turn on the printer and make a
test print.
FRU Disassembly/Assembly
3
Service Manual
8
5
4
9015-10
8-45