Configuring A Power Management Mode On A Poe Port - Cisco Catalyst 3750-E Software Configuration Manual

Chapter 12 Configuring Interface Characteristics
To disable auto-MDIX, use the no mdix auto interface configuration command.
This example shows how to enable auto-MDIX on a port:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# speed auto
Switch(config-if)# duplex auto
Switch(config-if)# mdix auto
Switch(config-if)# end

Configuring a Power Management Mode on a PoE Port

For most situations, the default configuration (auto mode) works well, providing plug-and-play
operation. No further configuration is required. However, use the following procedure to give a PoE port
higher priority, to make it data only, or to specify a maximum wattage to disallow high-power powered
devices on a port.
When you make PoE configuration changes, the port being configured drops power. Depending on the
Note
new configuration, the state of the other PoE ports, and the state of the power budget, the port might not
be powered up again. For example, port 1 is in the auto and on state, and you configure it for static mode.
The switch removes power from port 1, detects the powered device, and repowers the port. If port 1 is
in the auto and on state and you configure it with a maximum wattage of 10 W, the switch removes power
from the port and then redetects the powered device. The switch repowers the port only if the powered
device is a class 1, class 2, or a Cisco-only powered device.
Beginning in privileged EXEC mode, follow these steps to configure a power management mode on a
PoE-capable port:
Command
Step 1 configure terminal
Step 2
interface interface-id
OL-9775-08
Purpose
Enter global configuration mode.
Specify the physical port to be configured, and enter interface
configuration mode.
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
Configuring Ethernet Interfaces
12-27