Removing Cards - DataCard ImageCard IV User Manual

Using the printer
5
6
7
8

Removing cards

Remove completed cards from the output tray when an "Output tray full" message
appears or to distribute printed cards. The output tray holds up to 250 cards with a
nominal thickness of 0.030 inch (0.76 mm).
You can remove cards when the printer power is on or off, or while the printer is
printing.
1
2
3
User's Guide for the ImageCard® IV Printer
i
You can remove the card from the print station or allow the printer to clear the
card.
Replace the print ribbon cartridge. See
page 4-4.
Close the cover of the printer and press to latch it. If the printer has a lock, lock the
printer.
Select the Retry, Cancel, or Okay button on the message box displayed on the
PC.
The card moves to the reject bin.
Return to the card creation program to send the card to print again.
If the printer has a lock, unlock the printer. Lift the output tray cover and set aside
(step 1 in Figure 5-7).
Hold the card output tray and pull back on the card pusher. Lock it in the notch on
the bottom of the output tray (step 2 in
Figure 5-7: Remove completed cards
Lift cards from the output tray (step 3 in
Cards toward the front of the printer were printed before cards toward the rear of
the printer.
"Replacing the print ribbon cartridge" on
♦
Figure 5-7).
1
3
2
ICIV003U
Figure 5-7).
5-13