Appendix F: Laminate Material Default Settings; Topcoat; Laminate - DataCard ImageCard IV User Manual

L aminate material default
A
settings
This appendix describes the default settings to use for
different topcoat and laminate materials. Use these values:
•
•
Use the Advanced Setup Laminator -Advanced tab to view the values in the printer.
The default values are based on testing and should be used as starting points. You
might need to change these settings to compensate for differences in card stock,
supplies, and printers.

Topcoat

The following are default values for topcoat materials that can be used in a topcoat
station with a rubber-coated heated roller:
Material
Holographic Topcoat
Clear Topcoat
The following are default values for topcoat materials that can be used in a topcoat
station with a metal heated roller:
Material
Holographic Topcoat
Clear Topcoat

Laminate

The following are default values for laminate materials that can be used in an overlay
station with a rubber-coated roller:
Material
DuraGard™ 0.5 Mil
Clear Laminate
DuraGard 0.6 Mil
Holographic Laminate
User's Guide for the ImageCard® IV Printer
To compare with the settings currently used by the printer
To setup the option station for a material that is not included in the Material
Settings list in the Printer Toolbox
Temp
190
190
Temp
160
160
Speed Pressure
300 1550
300 1550
Speed Pressure
300 1550
300 1550
Temp Speed Pressure
210 200
210 200
1550
1550