DataCard ImageCard IV User Manual page 144

8-22
Laminate patch is off the
leading edge of the card.
Laminate patch is wrinkled
on the card.
Particles appear between
card and laminate patch.
Table 8-4: Overlay quality problems
What you see
An overlay patch is on the
driver roller.
The rollers are dirty.
The supply tracker is
slipping.
Jane Doe
Machine settings were
changed during service.
Supply roll is not pushed
firmly onto supply spindle
or take-up spool is not
pushed firmly onto take-up
spindle.
The supply spindle needs
adjustment.
Jane Doe
The inside of the printer is
dirty.
The heated roller is dirty.
The supplies were
mishandled.
The supplies are not
Datacard-recommended.
The printer is being used
in a dirty environment.
#
Obtain guidance from service before performing this task.
Possible causes
User's Guide for the ImageCard® IV Printer
Troubleshooting
Solutions
Use a cleaning card. See
Chapter 7.
Use a cleaning card. See
Chapter 7.
Clean the supply tracker.
See Chapter 7.
Be sure your hands and the
materials used are clean
and free of grease or oil.
Contact your service
representative.
Load the laminate supply
again. See Chapter 3.
Contact your service
representative.
Clean the inside of the
printer and use a cleaning
card. See Chapter 7.
Clean the heated roller. See
Chapter 7.
Store supplies in a clean
environment. Keep supplies
in packaging until loaded in
the cartridge. Handle pre-
loaded cartridges carefully
to avoid contamination.
Obtain and use Datacard-
recommended supplies.
Move the printer to a clean
environment or clean the
environment.