Load Cards - DataCard ImageCard IV User Manual

3-6

Load cards

1
2
3
i
4
5
6
E
If the printer is printing while you load cards, press the Ready button to pause the
printer (Figure 5-1).
Lift the input tray cover and set aside (step 1 in
Hold the card tray and slide the card pusher to the left (step 2 in
the card pusher in the notch on the bottom of the card tray.
Do not touch the surface of cards before printing them. Handle cards by the edges
or wear gloves to protect cards. Oils on hands can cause discolored printing.
Fan cards to separate the edges of cards (see Figure 3-6).
Align cards correctly. While facing the printer:
– Place the front surface of the card to the left.
– Place the magnetic stripe toward the top and facing to the right.
– Place the smart card chip toward the top and facing left.
Card input
tray cover
Card input tray
Card pusher
Figure 3-7: Load cards in the ImageCard IV printer
Place up to 250 cards in the space created by moving the card pusher back (step
3 in Figure 3-7).
If your cards are thicker or thinner than 0.030 inch (0.76 mm), the maximum
number of cards you can load changes.
Figure
Figure 3-6: Fan cards
Your name
1
2
ICIV001U
User's Guide for the ImageCard® IV Printer
Setting up the printer
3-7).
Figure 3-7). Latch
3